The Aeryn module was designed to allow air to be taken into the paludarium, heated and/or moisturized (mist) before it enters the setup. This is all part of the idea to have “no tech inside” but rather outside for easier access, maintenance and replace with updated versions.
What is Aeryn
Remember the sci-fi series “Farscape”? I originally designed this module named the Aether module. In honor of Farscape I renamed this module to Aeryn 🙂
The Aeryn module is a box-shaped module approximately 60x15x13cm in size, and is inserted into the hood above the paludarium. It lines up with two 12cm holes in the ceiling, where two fans draw in air from the outside. On the end of the module a 40mm pipe leads to the meshed strip on top of the paludarium where the conditioned air gets inserted.
Aeryn section 1: the air intake
The first section of the Aeryn module contains two 120mm fans, RPM regulated (and RPM measured back). These fans are put on top of the module, blowing down into the module. So first the airflow needs to be guided to flow sideways, which is accomplished using a 3D printed guide as shown below:
[…] to the “C”. Today I still program in both “C” and Python for fun (Arduino and Raspberry Pi […]